ANADDB ERROR

Phonons, DFPT, electron-phonon, electric-field response, mechanical response…

Moderators: mverstra, joaocarloscabreu

Locked
nayoung
Posts: 4
Joined: Mon Jan 19, 2015 11:14 am

ANADDB ERROR

Post by nayoung » Thu Jan 29, 2015 7:17 am

Dear all
I want analysis DDB in my result about non-linear calculation.
But I have a ERROR

My calculation was broken after below the words:
rdddb9 : read 2 blocks from the input DDB
Now the whole DDB is in central memory
gtblk9 : enter gtblk9
gtblk9 :
Unable to find block corresponding to the following specifications :
Type (rfmeth) = 1
ider qphon(3) qphnrm rfphon rfelfd rfstrs
1 0.00 0.00 0.00 0.00 1 0 0
2 0.00 0.00 0.00 0.00 1 0 0
gtblk9 : enter gtblk9
gtblk9 :
Unable to find block corresponding to the following specifications :
Type (rfmeth) = 1
ider qphon(3) qphnrm rfphon rfelfd rfstrs
1 0.00 0.00 0.00 0.00 1 2 0
2 0.00 0.00 0.00 0.00 1 2 0
gtblk9 : enter gtblk9
gtblk9 :
Unable to find block corresponding to the following specifications :
Type (rfmeth) = 3
ider qphon(3) qphnrm rfphon rfelfd rfstrs
1 0.00 0.00 0.00 1.00 1 2 0
2 0.00 0.00 0.00 1.00 0 2 0
3 0.00 0.00 0.00 1.00 0 2 0

mpirun noticed that process rank 0 with PID 8566 on node ny exited on signal 11 (Segmentation fault).

How can I resolve the problem?
Best regards.
Attachments
tnlo_5.in
(715 Bytes) Downloaded 320 times

mverstra
Posts: 655
Joined: Wed Aug 19, 2009 12:01 pm

Re: ANADDB ERROR

Post by mverstra » Tue May 05, 2015 10:37 am

please read and follow the nettiquette on the main forum page.

You should probably not be running anaddb in parallel. In particular if you are using a version before 7.10, and for most purposes there is no need.

Try to run without the NL part to make sure your main ddb is correct.
Matthieu Verstraete
University of Liege, Belgium

Locked